Final Calibration and wrap up.

XIII.         In order to calibrate the sensor, connect the other side of the push button to ground. At this point you will need to take the car up to around 6000 RPM. Press the calibration button while coasting down in gear. If the gas is pressed during this process, the process will need to be repeated. Once the calibration is complete, un-ground the 2^nd side of the calibration switch.

XIV.         Open X-map 3.2>Diagnosis>Live Data Display.

XV.           With the data display open, look at the inputs called AN0, and AN1. AN0 should read about 15% at idle, up to around 20% at 6000 RPM in neutral. To verify that the wideband is work, rev the car, and watch AN1 to make sure you are seeing substantial changes in the percentages. Without the wideband input properly, AN1 will stay static around 49%.

C-Reader:

In order to install the Creader, use only the reader itself. Plug this reader in to the OBDII port on the right hand side of the steering colum, under the dash board.