*Optional Launch Control and No Lift Shift*

            This feature requires the extra terminated connector. Newer SMART kits will include this wire. (If yours was in the first batch, contact Vishnu for this wire free of charge.)

I.                    Locate the connector 2^nd from the right on the factory ECU. On this connector, there is a light green wire, which is the same color as the boost wire. This wire is the 4^th wire in from the right on the flat side, right next to the empty pin.

II.                 Extract this wire in the same fashion as the boost wire, by unlocking the white bar on the connector, then lifting up on the tab that holds in the pin.

III.               With this clutch switch wire extracted, connect the light green wire to the wire provide by Vishnu, and shrink rap the connection.

IV.              Feed this wire into pin 1 on the black connector of the xede.