Recipe File for XEDE TSP
------------------------
[File Info]
Original Date=5 Aug 2004
Original Author=RD
Revision=V1.1
; V1.0   5 Aug 2004: Prototype; no versioning adhered to really
; V1.1   3 Apr 2006: Add wired bypass lines
Revision Date=3 Apr 2006
Copyright=(C) 2006 ChipTorque


[Vehicle Info]
;This info is stored in EE; total < 32 characters
Waveform=4-Even, Hall Rising
Vehicles=Mitsubishi 4

[TSP Setup]
Prescale=36
Shift per Change=1
: 0.1 deg
Edges per Change=200
: shift by 0.1 deg every 20 degrees
Active Edge=Rising
Error Detection Enabled=0
Error Tolerance=25
: percent
Pattern Sync Address=1
Sync Pulse Count=2
: = pulses - 1 in this case
: For PP-only case
Sync Method=Pulses
: Either 'Comparison' or 'Pulses'
Comparison Type=PP
: Either 'PP' or 'PW'
Greater Than Next=0
Greater Than Previous=0
Sync Threshold 0.25=0
Sync Threshold 0.5=0
Sync Threshold 1=0
Input Hysteresis=10
: Must be < 127
Minimum Pulse Width=10
: In prescaled clock cycles

[Simulator Setup]
Playback Rate=100
Run Simulator=1
Invert Output=1
Wire to Output=0
Wire to Input=0

[Startup Control]
; This is the RPM level that must be reached before the xede will change over after
; startup
Startup RPM=1500
; Enter next line in seconds
Startup Delay=.5
; Enter 0 or 1 (yes or no) for next line; Needs XMap3.0.3.6 or later and XProc V3.1.14 or later..
Use Wired Bypass=0


[Pattern]
; Use PPx (Pulse-Pulse), and PWx (Pulse Width);  amounts = degrees
; Max pairs = 128
PP1=1800
PW1=700
PP2=1800
PW2=700
; End of file.